steve72
Posts : 20 Join date : 2013-03-14 Age : 51 Location : Tyler Tx.
| Subject: 04-06 roll cage Thu Mar 14, 2013 6:00 pm | |
| I have a Cage that is choped down for better clearence through low limb trails. It has tabs welded on front post near hood to mount lights. I also have a plain roof that goes on it. I repositioned the mount tabs so it would still fit. The rear of roof was cut to allow snorkles to go to roof height. ( yes it has been handy to be up there) I will let the whole thing go for $200 obo pick up!! or plus shipping if possible? (above pic is cage and roof befor I took it off). Would be great for anyone who wanted to keep their stock cage for resale, or just worried about not getting it right...This thing has support tubing inside were it was cut (4"on bothside of cut) and spot weld to hold in place then full weld seam.
Last edited by steve72 on Thu Mar 14, 2013 6:05 pm; edited 2 times in total | |
|
steve72
Posts : 20 Join date : 2013-03-14 Age : 51 Location : Tyler Tx.
| Subject: Re: 04-06 roll cage Thu Mar 14, 2013 6:00 pm | |
| | |
|
bubba53
Posts : 117 Join date : 2013-04-07 Age : 70 Location : statesville,nc
| Subject: Re: 04-06 roll cage Sun Apr 07, 2013 11:37 am | |
| | |
|
txgrown1404
Posts : 193 Join date : 2013-03-22 Age : 45 Location : wichita falls, Tx
| Subject: Re: 04-06 roll cage Thu Apr 11, 2013 8:51 pm | |
| - steve72 wrote:
- I have a Cage that is choped down for better clearence through low limb trails. It has tabs welded on front post near hood to mount lights. I also have a plain roof that goes on it. I repositioned the mount tabs so it would still fit. The rear of roof was cut to allow snorkles to go to roof height. ( yes it has been handy to be up there) I will let the whole thing go for $200 obo pick up!! or plus shipping if possible? (above pic is cage and roof befor I took it off). Would be great for anyone who wanted to keep their stock cage for resale, or just worried about not getting it right...This thing has support tubing inside were it was cut (4"on bothside of cut) and spot weld to hold in place then full weld seam.
what kind of doors are those? | |
|
doughjk
Posts : 22 Join date : 2013-04-02
| Subject: Re: 04-06 roll cage Thu Apr 11, 2013 9:51 pm | |
| do you have to lower seats to do 4" chop? I'm 6' and worried about headroom | |
|
Sponsored content
| Subject: Re: 04-06 roll cage | |
| |
|